2500W Phase Control

This circuit controls resistive and inductive loads up to 2,500W. It's main functional device is an integrated phase control circuit - Siemens TLE3103. It contains its own power supply, a zero voltage crossing detector circuit and a logic driver. An additional feature is the low voltage input to enable/disable triac firing enabling/disabling the logic driver. The function is as follows: pin13 TLE3103 open (floating), trigger output active, tied to ground trigger output disabled.

2500W Phase Control  Circuit diagram


An UP and a DOWN button control a 32-step digital potentiometer (IC2, AD5228) via the debouncer IC1 (MAX6817). The potentiometer has a power on reset pin which might be tied to ground causing the potentiometer to start at midscale, or to VCC causing it to start at zero scale. The desired function is selectable using jumper JP1. The triac (capable of driving 40A loads) is a bit overkill for the desired power but the BTA41 has an isolated body and therefore handling of the board under voltage is less dangerous as it is with phase on the package. The circuit uses a 68μH inductance, but this might be replaced with a 100 resistor, then replacing the inductance C5 should have a value of 47nF.
Share this article

0 comments:

Post a Comment

 
Copyright © 2019 W3circuits.blogspot.com • All Rights Reserved.
back to top